Search results
Results from the WOW.Com Content Network
ATATool must be run with administrator privileges. On Windows Vista and later it requires an elevated-privileges command prompt (see User Account Control). The target drive must be connected to a physical disk controller. The software will not work when using a hard drive through an external connection like USB or any external hard drive.
Moving the HDD controller from the interface card to the disk drive helped to standardize the host/controller interface, reduce the programming complexity in the host device driver, and reduced system cost and complexity. The 40-pin IDE/ATA connection transfers 16 bits of data at a time on the data cable.
The SCSI commands and responses are embedded in "packets" (hence "ATA Packet Interface") for transmission on the ATA cable. This interfaces ATA with any device class for which a SCSI command set has been defined. ATAPI devices are also "speaking ATA" because the ATA physical interface and protocol are still being used to send the packets.
Parallel ATA (PATA), originally AT Attachment, also known as Integrated Drive Electronics (IDE), is a standard interface designed for IBM PC-compatible computers.It was first developed by Western Digital and Compaq in 1986 for compatible hard drives and CD or DVD drives.
Around 1997, with the introduction of ATAPI-4 (and thus Ultra-DMA-Mode, which enabled fast data transfers with less CPU utilization) the first ATA RAID controllers were introduced as PCI expansion cards. Those RAID systems made their way to the consumer market, for users wanting the fault-tolerance of RAID without investing in expensive SCSI ...
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
The Read(10), Read(12), Read Long, Write(10), Write(12), and Write Long commands all contain a 32-bit LBA address plus various other parameter options. The capacity of a "sequential access" (i.e. tape-type) device is not specified because it depends, amongst other things, on the length of the tape, which is not identified in a machine-readable way.
Seagate ST11R, an 8-bit ISA RLL hard disk controller produced in 1990. A disk controller is a controller circuit that enables a CPU to communicate with a hard disk, floppy disk or other kind of disk drive. It also provides an interface between the disk drive and the bus connecting it to the rest of the system. [1] [2]