enow.com Web Search

  1. Ad

    related to: unique well pump covers decorative water drain valve location

Search results

  1. Results from the WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  3. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.

  4. Water well pump - Wikipedia

    en.wikipedia.org/wiki/Water_well_pump

    Injector, a jet-driven pump; Mechanical or rotary lobe pump requiring mechanical parts to pump water; Solar-powered water pump; Pump driven by air as used by the Amish; Pump driven by air as used in the Australian outback; Manual pumpless or hand pump wells requiring a human operator; The pump replaces the use of a bucket and pulley system to ...

  5. Drain (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Drain_(plumbing)

    Pool drain vortex as viewed from above the water at Grange Park wading pool Underwater view of drain, showing vortex-formation phenomenon. A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed.

  6. Well drainage - Wikipedia

    en.wikipedia.org/wiki/Well_drainage

    The well filter must be placed in a permeable soil layer. The spacing can be calculated with a well spacing equation using discharge, aquifer properties, well depth and optimal depth of the water table. The determination of the optimum depth of the water table is the realm of drainage research.

  7. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

  8. Gatehouse (waterworks) - Wikipedia

    en.wikipedia.org/wiki/Gatehouse_(waterworks)

    The Kinzua Dam in Pennsylvania, with outlet works releasing water. A gatehouse, gate house, outlet works or valve house for a dam is a structure housing sluice gates, valves, or pumps (in which case it is more accurately called a pumping station). Many gatehouses are strictly utilitarian, but especially in the nineteenth century, some were very ...

  9. Injection well - Wikipedia

    en.wikipedia.org/wiki/Injection_well

    The activation can be as simple as inserting a polymer cover (foil) into the well shaft. Vertical pipes for conduction of the overflow to the bottom can enhance performance. The area around the well acts as funnel. If this area is maintained well the water will require little purification before it enters the cistern. [13]

  1. Ad

    related to: unique well pump covers decorative water drain valve location