Search results
Results from the WOW.Com Content Network
A standard dew point that is expected by a regenerative dryer is −40 °C (−40 °F); this means that when the air leaves the dryer there is as much water in the air as if the air had been "cooled" to −40 °C (−40 °F). Required dew point is dependent on application and −70 °C (-94 °F) is required in some applications.
Bendix Corporation is an American manufacturing and engineering company which, during various times in its existence, made automotive brake shoes and systems, vacuum tubes, aircraft brakes, aeronautical hydraulics and electric power systems, avionics, aircraft and automobile fuel control systems, radios, televisions and computers.
Most weld purging is carried out on joints made by the TIG or GTAW arc welding process. [6] When the laser welding process is chosen, joints or welds being made on reactive materials will need to be carried out and in the case of electron beam welding, this is carried out in a vacuum, in which case purging takes place by complete evacuation of all gas.
At the air inlet, air temperature must be lower than the upper ambient rating of the fan (typically 50 °C/122 °F). The position of air intake is at a point where the least amount of dust, oil, and moisture collects. Fail safe shutters protect the instrument if the purge air supply fails. These are key in systems where the flue gas is under ...
This process is known as volatization or air stripping. Water is deposited into the system through the top and air is ventilated in through the bottom. Water that reaches the bottom of the system is typically considered treated, but additional testing may be done to determine if it is safe for consumption. [1]
Using the same principles as the pressure carburetor to measure air flow into the engine, the distributed fuel injection system used individual fuel lines to each cylinder, injecting the fuel at the intake port. The direct-injection systems differed from a pressure carburetor in that the fuel is introduced just up stream from the intake valve ...
A Bendix drive is a type of engagement mechanism used in starter motors of internal combustion engines.The device allows the pinion gear of the starter motor to engage or disengage the ring gear (which is attached to the flywheel or flexplate of the engine) automatically when the starter is powered or when the engine fires, respectively.
Bendix G-15 computer, 2015 A read amplifier module from a G-15. The Bendix G-15 is a computer introduced in 1956 [1] [2] [3] by the Bendix Corporation, Computer Division, Los Angeles, California. It is about 5 ft × 3 ft × 3 ft (1.52 m × 0.91 m × 0.91 m) and weighs about 966 lb (438 kg).