Search results
Results from the WOW.Com Content Network
This command is often used to obtain the IP of an abusive user to more effectively perform a ban. It is unclear what, if any, privileges are required to execute this command on a server. This command is not formally defined by an RFC, but is in use by some IRC daemons. Support is indicated in a RPL_ISUPPORT reply (numeric 005) with the USERIP ...
The CTCP PING command works by sending an (often) integer argument (a timestamp) to a target client, the target client then responds by supplying exactly the same numerical parameter. The difference between the original timestamp and the current timestamp is calculated, with the result being displayed to the user that initiated the CTCP PING.
Thread is an IPv6-based, low-power mesh networking technology for Internet of things (IoT) products. [1] The Thread protocol specification is available at no cost; however, this requires agreement and continued adherence to an end-user license agreement (EULA), which states "Membership in Thread Group is necessary to implement, practice, and ship Thread technology and Thread Group specifications."
Discord is an instant messaging and VoIP social platform which allows communication through voice calls, video calls, text messaging, and media. Communication can be ...
The traceroute command can be implemented by transmitting IP datagrams with specially set IP TTL header fields, and looking for ICMP time exceeded in transit and destination unreachable messages generated in response. The related ping utility is implemented using the ICMP echo request and echo reply messages.
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available in a wide range of operating systems – including most embedded network administration software.
The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination. The sum of the mean times in each hop is a measure of the total time spent to establish the connection. The command aborts if all (usually three) sent packets are lost more than twice.
RTT is a measure of the amount of time taken for an entire message to be sent to a destination and for a reply to be sent back to the sender. The time to send the message to the destination in its entirety is known as the network latency, and thus RTT is twice the latency in the network plus a processing delay at the destination.