Search results
Results from the WOW.Com Content Network
The 4.3 L (262 cu in) also used larger valves than the 229 cu in (3.8 L) V6, with a 1.94-inch (49.3 mm) intake valve and a 1 + 1 ⁄ 2-inch (38.1 mm) exhaust valve (also shared with the 350). [ 2 ] In 1986 and 1987, the 4.3 L (262 cu in) engine saw engine design upgrades similar to the Chevrolet small block V8.
It has a 4.125-inch (104.8 mm) bore and a 3.750-inch (95.25 mm) stroke. The 400 differed from other small-blocks in that the cylinders were siamesed and therefore required 'steam' holes in the block, head gaskets, and heads to help alleviate 'hot-spots' in the cooling system at the point above the siamesed cylinders.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The 2.0 litre version was a narrower-bore version of the original 2.3 liter "Lima" four. Bore and stroke are 89.3 and 79.4 mm (3.52 and 3.13 in), respectively, for an overall displacement of 2.0 L; 121.4 cu in (1,990 cc). This engine was installed in the 1983–1988 Ford Rangers and in some Argentinian Ford Taunus. Applications
Bore and stroke size is 3.552 in × 4.165 in (90.2 mm × 105.8 mm), identical to the 5.4 L V8. Both 2-valve and 3-valve versions have been produced. The 6.8 L uses a split-pin crank with 72° firing intervals and a balance shaft gear driven by the left camshaft to quell vibrations inherent to a 90° bank angle V10 engine.
Diagram 3 shows three rope parts supporting the load W, which means the tension in the rope is W/3. Thus, the mechanical advantage is three-to-one. By adding a pulley to the fixed block of a gun tackle the direction of the pulling force is reversed though the mechanical advantage remains the same, Diagram 3a. This is an example of the Luff tackle.
A peristaltic pump, also commonly known as a roller pump, is a type of positive displacement pump used for pumping a variety of fluids. The fluid is contained in a flexible tube fitted inside a circular pump casing. Most peristaltic pumps work through rotary motion, though linear peristaltic pumps have also been made.
For 2006, engines had to be a 90° V8 configuration of 2.4 litres maximum capacity with a circular bore of 98 mm (3.9 in) maximum, which implies a 39.8 mm (1.57 in) stroke at maximum bore. The engines must have two inlet and two exhaust valves per cylinder, be naturally aspirated and have a 95 kg (209 lb) minimum weight.