Search results
Results from the WOW.Com Content Network
A low-flow fixture is a water saving plumbing fixture designed to achieve water savings by having a lower flow rate of water or a smaller quantity per flush. Some of these low-flow fixtures are faucets , showerheads, and toilets .
A water outlet. Each of these plumbing fixtures has one or more water outlets and a drain. In some cases, the drain has a device that can be manipulated to block the drain to fill the basin of the fixture. Each fixture also has a flood rim, or level at which water will begin to overflow. Most fixtures also have an overflow, which is a conduit ...
The pressure-balanced shower valve compensates for changes in water pressure. It has a diaphragm or piston inside that reacts to relative changes in either hot or cold water pressure to maintain balanced pressure. As water pressure drops on one supply line, the valve reduces the pressure in the other supply line to match.
Brine draw: Water is directed through a jet pump, which pulls salt water from the brine tank, before the water and brine pass through the resin bed in the normal direction, if co-current, or in the reverse direction, if counter-current. [12] The output of this typically thirty-minute process is discarded through the drain hose.
Under the right conditions (if the water supply loses pressure and the sink is higher than the point at which the water supply enters the house, for instance), the dirty water in the sink could be siphoned backwards into the water pipes through the hose and faucet. The dirty water could then be dispersed throughout the drinking water system.
The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower and a need for pumping water to a destination ...
When an aerator is added to the faucet (or fluid stream), there is a region of high pressure created behind the aerator. Because of the higher pressure behind the aerator and the low pressure in front of it (outside the faucet), due to Bernoulli's principle there is an increase in velocity of the fluid flow.
Also, the tortuous S-shaped path the water is forced to follow offers a significant obstruction to the flow. For high pressure domestic water systems this does not matter, but for low pressure systems where flow rate is important, such as a shower fed by a storage tank, a "stop tap" or, in engineering terms, a "gate valve" is preferred.