enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Riser clamp - Wikipedia

   en.wikipedia.org/wiki/Riser_clamp

   A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them onto the pipe. [1] [2] The friction between the pipe and riser clamp

3. Hold down (structural engineering) - Wikipedia

   en.wikipedia.org/wiki/Hold_down_(structural...

   A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...

4. Pipe support - Wikipedia

   en.wikipedia.org/wiki/Pipe_support

   A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation. The four main functions of a pipe support are to anchor, guide ...

5. Insulating concrete form - Wikipedia

   en.wikipedia.org/wiki/Insulating_concrete_form

   Like other concrete formwork, the forms are filled with concrete in 1-foot to 4-foot high "lifts" to manage the concrete pressure and reduce the risk of blowouts. After the concrete has cured, the forms are left in place permanently to provide a variety of benefits, depending on materials used: Thermal insulation; Soundproofing

6. U-bolt - Wikipedia

   en.wikipedia.org/wiki/U-bolt

   The nominal bore of a pipe is actually a measurement of the inside diameter of the pipe. Engineers are interested in this because they design a pipe by the amount of fluid / gas it can transport. As U-bolts are now being used by a much wider audience to clamp any kind of tubing / round bar, then a more convenient measurement system needs to be ...

7. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The clamp is placed over the end of the hose or tube to be connected and when each ear is closed at the base of the ear with a special pincer tool, it permanently deforms, pulling the band, and causing the band to tighten around the hose. The size of clamp should be chosen such that the ear(s) are almost completely closed on installation.