Ad
related to: modern steam heat radiators and loud noises in house- Sustainability Commitment
Determined to lead change
for a better world.
- Uponor Kitting Services
Simplify installations and
increase efficiencies.
- Uponor Contractor Rewards
Earn rewards and get exclusive
promotions just for the pros.
- Commercial Solutions
Superior systems with
exceptional support.
- Sustainability Commitment
Search results
Results from the WOW.Com Content Network
Steam pipes and radiators are prone to producing banging sounds called steam hammer. The bang is created when some of the steam condenses into water in a horizontal section of the steam piping. Subsequently, steam picks up the water, forms a "slug" and hurls it at high velocity into a pipe fitting, creating a loud hammering noise and greatly ...
A steam heating system takes advantage of the high latent heat which is given off when steam condenses to liquid water. In a steam heating system, each room is equipped with a radiator which is connected to a source of low-pressure steam (a boiler). Steam entering the radiator condenses and gives up its latent heat, returning to liquid water.
Extreme heat can cause roof shingles to curl, crack, or even fall off, says Derek Perzylo, co-owner of Big 5 Exteriors Ltd., an exterior services contractor in Calgary. When it’s hot, the ...
In the oldest modern hydronic heating technology, a single-pipe steam system delivers steam to the radiators where the steam gives up its heat and is condensed back to water. The radiators and steam supply pipes are pitched so that gravity eventually takes this condensate back down through the steam supply piping to the boiler where it can once ...
Radiant heating and cooling is a category of HVAC technologies that exchange heat by both convection and radiation with the environments they are designed to heat or cool. There are many subcategories of radiant heating and cooling, including: "radiant ceiling panels", [ 1 ] "embedded surface systems", [ 1 ] "thermally active building systems ...
By comparison, most modern "warm air" furnaces typically use a fan to circulate air to the rooms of house and pull cooler air back to the furnace for reheating; this is called forced-air heat. Because the fan easily overcomes the resistance of the ductwork, the arrangement of ducts can be far more flexible than the octopus of old.
The Pierce Steam Heating Company was founded in 1881 by John B. Pierce and Joseph Bond in Buffalo. [3] The Standard Radiator Company (Buffalo) was established in 1892 by Nelson Holland. [4] Advertisement for boilers from the American Radiator Company, illustrated by Ralph Barton, published in The Elks Magazine, May 1924
The Argentinian engineer Livio Dante Porta in the development of Stephensonian railway locomotives incorporating advanced steam technology was a precursor of the 'Modern Steam' movement from 1948. [ 11 ] : 3–6 Where possible, Porta much preferred to design new locomotives, but more often in practice he was forced to radically update old ones ...
Ad
related to: modern steam heat radiators and loud noises in house