Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
This is accomplished by using metal ties fastened to each rafter or truss. This is not normally a problem in areas not prone to high wind or extreme weather conditions. In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers.
Concrete landscape curbing (or concrete landscape bordering) is an alternative to plastic or metal landscape edging. Landscape curbing is made with various elements of concrete depending on the climate where it is being used. [1] Concrete landscape curbing has become more popular over the last decade with suppliers offering a variety of styling ...
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
Joe Burrow entered Sunday with a career-high 36 touchdown passes in a standout campaign for the Cincinnati Bengals. His 37th was one of his best of the season.
NFL fans skewered the officials in the wild-card game between the Buffalo Bills and Denver Broncos over a questionable no call on Sunday.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
The Federal Reserve’s top banking regulator Michael Barr will step down from his position in February, saying that "the risk of a dispute over the position could be a distraction from our mission."