Search results
Results from the WOW.Com Content Network
LT: Designates that this is a light truck tire. Load index and speed rating are sometimes not mandatory for flotation sizes, but must be for any tire approved for street and highway use. 2- or 3-digit number: Load index; see table below. 1- or 2-digit/letter combination: Speed rating; see table below. Additional marks: see subheading below.
In this condition, the device that is capable of autonegotiation can determine and match speed with the other device. This procedure cannot determine duplex capability, so half duplex is always assumed. Other than speed and duplex mode, autonegotiation is used to communicate the master-slave parameters for gigabit Ethernet. [10] [11]
The Ethernet physical layer has evolved over its existence starting in 1980 and encompasses multiple physical media interfaces and several orders of magnitude of speed from 1 Mbit/s to 800 Gbit/s. The physical medium ranges from bulky coaxial cable to twisted pair and optical fiber with a standardized reach of up to 80 km.
RJ11(C/W) 6P2C: Establishes a bridged connection for one telephone line (6P4C if power on second pair). In computers, it is often used for dial-up internet access. [7] RJ12(C/W) 6P6C: Establishes a bridged connection for one telephone line with key telephone system control ahead of line circuit RJ13(C/W) 6P4C: Similar to RJ12, but behind the ...
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.
These represent the tire's resistance to the generation of heat at speed. Tires graded A effectively dissipate heat up to a maximum speed that is greater than 115 mph. B rates at a maximum between 100 mph and 115 mph. C rates at a maximum of between 85 mph to 100 mph. Tires that cannot grade up to C or higher cannot be sold in the US. [9]
The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]
This page was last edited on 30 November 2013, at 17:10 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 3.0; additional terms may apply.