Search results
Results from the WOW.Com Content Network
This bracing is known by many names such as herringbone strutting, blocking, bridging, and dwanging. Cross bracing on a bridge tower. In construction, cross bracing is a system utilized to reinforce building structures in which diagonal supports intersect. Cross bracing is usually seen with two diagonal supports placed in an X-shaped manner.
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
X-bracing is a structural engineering practice where the lateral load on a building is reduced by transferring the load into the exterior columns. X-bracing was used in the construction of the 1908 Singer Building , then the tallest building in the world.
Construction aggregate – Construction engineering – Construction surveying – Corbel – Corinthian order – Corrosion – Corrosion fatigue – Corrugated galvanised iron – Crane – Cross brace – Cross bracing – Curvilinear motion
As cross-bracing cannot normally be added, vertical stiffeners on the girders are normally used to prevent buckling (technically described as 'U-frame behaviour' [5]). This form of bridge is most often used on railroads as the construction depth (distance between the underside of the vehicle, and the underside of the bridge) is much less.
Construction buyer; Construction delay; Construction engineering; Construction management; Construction surveying; Construction trailer; Contour crafting; Cooling load; Cooling tower; Course (architecture) Cross bracing; Cross ventilation; Crosswall construction; Crypt; Curtain wall (architecture) Cut (earthworks) Cut and fill
In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.
This includes the girders themselves, diaphragms or cross-braces, and (if applicable) the truss or arch system. In a girder bridge this would include only the girders and the bracing system. The girders are the primary load support, while the bracing system both allows the girders to act together as a unit, and prevents the beams from toppling.