Search results
Results from the WOW.Com Content Network
The process capability index, or process capability ratio, is a statistical measure of process capability: the ability of an engineering process to produce an output within specification limits. [1]
The process capability is a measurable property of a process to the specification, expressed as a process capability index (e.g., C pk or C pm) or as a process performance index (e.g., P pk or P pm).
Consider a quality characteristic with a target of 100.00 μm and upper and lower specification limits of 106.00 μm and 94.00 μm, respectively. If, after carefully monitoring the process for a while, it appears that the process is out of control and producing output unpredictably (as depicted in the run chart below), one can't meaningfully estimate its mean and standard deviation.
In other words, they assume that after the initial study determining the short-term sigma level, the long-term C pk value will turn out to be 0.5 less than the short-term C pk value. So, now for example, the DPMO figure given for 1 sigma assumes that the long-term process mean will be 0.5 sigma beyond the specification limit (C pk = –0.17 ...
To calculate the E192 series: is 192, then is incremented from 0 to 191 through the formula, with one exception for = where 9.20 is the official value instead of the calculated 9.19 value. Since some values of the E24 series do not exist in the E48, E96, or E192 series, some resistor manufacturers have added missing E24 values into some of ...
Liver function tests (LFTs or LFs), also referred to as a hepatic panel or liver panel, are groups of blood tests that provide information about the state of a patient's liver. [1]
A blackbody at 6000 K puts out 7348 W per square centimetre, so a value for u of 44% and a value of 5.73 × 10 18 photons per joule (corresponding to a band gap of 1.09 V, the value used by Shockley and Queisser) gives Q s equal to 1.85 × 10 22 photons per second per square centimetre.
The SAR value is then measured at the location that has the highest absorption rate in the entire head, which in the case of a mobile phone is often as close to the phone's antenna as possible. Measurements are made for different positions on both sides of the head and at different frequencies representing the frequency bands at which the ...