Search results
Results from the WOW.Com Content Network
The Princeton circuits up through 5C2 differed from the Fender Champ in having two versus one preamp stage (6SC7 dual-triode vs 6SJ7 pentode) and added the tone control that was absent in the Champs; the 12AX7-based Princeton models 5D2 through 5F2-A were essentially the Champ circuits 5D1 through 5F1 with a tone control and a somewhat larger ...
2.0 mm: 4.0 mm: MX1A-11xx >100 million Cherry: Cherry: Red [2] Cherry MX Red: Linear: 0.45 N: N/A: ... On top of a variety of new switches being made, consumers are ...
This Paul Rivera-specified Fender guitar amplifier was introduced in 1982 to replace the Princeton Reverb. [1] It was a completely different and significantly more powerful amplifier. [ 2 ] Designed by Ed Jahns, it featured a built-in reverb, treble boost and mid boost controls, and a switchable lead (overdrive) effect.
EMS-1 (The ITEC Electronic Modular Switch is an electronic direct control switching system. The modules are combined to form a complete switch or any of the modules can be added to your present Step-by-Step Systems.) EMS-2 (The EMS-2 RURAL SWITCH is a stored program control analog switch designed to be cost-effective in small exchanges.
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.
The utilization of the binary properties of electrical switches to perform logic functions is the basic concept that underlies all electronic digital computer designs. Shannon's thesis became the foundation of practical digital circuit design when it became widely known among the electrical engineering community during and after World War II.
Switching uses different kinds of network switches. A standard switch is known as a layer-2 switch and is commonly found in nearly any LAN. Layer-3 or layer-4 switches require advanced technology (see managed switch) and are more expensive and thus are usually only found in larger LANs or in special network environments.
A rotary switch is a switch operated by rotation. These are often chosen when more than 2 positions are needed, such as a three-speed fan or a CB radio with multiple frequencies of reception or "channels". A rotary switch consists of a spindle or "rotor" that has a contact arm or "spoke" which projects from its surface like a cam.