enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. MacFam Cavalier - Wikipedia

   en.wikipedia.org/wiki/MacFam_Cavalier

   The MacFam Cavalier is a homebuilt aircraft designed by Stan McLeod, developed through a progressing series of models, all using all-wooden construction. The model range includes the SA102, SA102.5, SA103, SA104 and the SA105. [1] [2]

3. Wright R-1300 Cyclone 7 - Wikipedia

   en.wikipedia.org/wiki/Wright_R-1300_Cyclone_7

   Engineering began in 1942 but the first flight of an R-1300 did not take place until 1949. The engine was produced under license by Kaiser-Frazer and later by AVCO Lycoming. [2] The engine was used in combat — the R-1300-1A and -1B in the A model North American T-28 Trojan and the R-1300-3, -3A, -3C and -3D in the Sikorsky H-19 Chickasaw.

4. MORGOIL Bearings - Wikipedia

   en.wikipedia.org/wiki/MORGOIL_Bearings

   MORGOIL bearings provided higher load capacities, higher speed capabilities, lower power consumption, and longer life than existing bearing choices [2] MORGOIL bearings are totally enclosed, precision journal bearings that operate on a hydrodynamically generated film of oil. This oil film has a very high load-carrying capacity, and since there ...

5. NBC Bearings - Wikipedia

   en.wikipedia.org/wiki/NBC_Bearings

   NBC Bearings is the brand of National Engineering Industries Limited (NEIL), a part of CK Birla Group. National Engineering Industries (NEIL) was founded in 1946 and is engaged in the manufacturing of bearings for the automotive, railway , industrial, and aerospace industries.

6. Main bearing - Wikipedia

   en.wikipedia.org/wiki/Main_bearing

   The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).

7. Rod end bearing - Wikipedia

   en.wikipedia.org/wiki/Rod_end_bearing

   A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...