Search results
Results from the WOW.Com Content Network
A reinforced concrete column is a structural member designed to carry compressive loads, composed of concrete with an embedded steel frame to provide reinforcement. For design purposes, the columns are separated into two categories: short columns and slender columns.
The slenderness ratio is an indicator of the specimen's resistance to bending and buckling, due to its length and cross section. If the slenderness ratio is less than the critical slenderness ratio, the column is considered to be a short column. In these cases, the Johnson parabola is more applicable than the Euler formula. [5]
The -ette suffix, from French language, is a diminutive, which can also have a condescending connotation: in our case, it shifts the meaning from column to small column or fake columns. In the field of Angkorian archeology, Edme Casimir de Croizier was the first to use the name of colonnette in his study of Khmer art in 1875. [ 9 ]
In practical design, it is recommended to increase the factors as shown above. The following assumptions are made while deriving Euler's formula: [3] The material of the column is homogeneous and isotropic. The compressive load on the column is axial only. The column is free from initial stress. The weight of the column is neglected.
A steel column is extended by welding or bolting splice plates on the flanges and webs or walls of the columns to provide a few inches or feet of load transfer from the upper to the lower column section. A timber column is usually extended by the use of a steel tube or wrapped-around sheet-metal plate bolted onto the two connecting timber sections.
The Ionic column is always more slender than the Doric; therefore, it always has a base: [5] Ionic columns are eight and nine column-diameters tall, and even more in the Antebellum colonnades of late American Greek Revival plantation houses. [citation needed] Ionic columns are most often fluted. After a little early experimentation, the number ...
Greek Doric columns had no base, and this prevented the flutes, which ended in a sharp arris, being worn down by people brushing past. [3] The flutes continue right down to the base of the column, [21] and at the top usually pass through three very narrow bands cut into the stone before reaching the base of the capital, where the shaft swells ...
A beam is a structural element that primarily resists loads applied laterally across the beam's axis (an element designed to carry a load pushing parallel to its axis would be a strut or column). Its mode of deflection is primarily by bending , as loads produce reaction forces at the beam's support points and internal bending moments , shear ...