enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   The micro ribbon connector, first made by Amphenol, that is used in the RJ21 interface, has also been used to connect Ethernet ports in bulk from a switch with 50-pin ports to a Cat-5 rated patch panel, or between two patch panels. A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a ...

3. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel. Keystone modules have a rectangular face of 14.5 mm wide by 16.0 mm high and are held in place with flexible tabs.

4. GG45 - Wikipedia

   en.wikipedia.org/wiki/GG45

   GG45 (GigaGate 45) and ARJ45 (Augmented RJ45) are two related connectors for Category 7, Category 7 A, and Category 8 telecommunication cabling. The GG45 interface and related implementations are developed and sold by Nexans S.A. , while the ARJ45 interface and related implementations are developed and sold by Bel Fuse Inc.

5. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   A punch down tool with interchangeable blades. A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians.

6. Feedthrough - Wikipedia

   en.wikipedia.org/wiki/Feedthrough

   A feedthrough is a conductor used to carry a signal through an enclosure or printed circuit board. Like any conductor, it has a small amount of capacitance . A "feedthrough capacitor" has a guaranteed minimum value of shunt capacitance [ clarify ] built in it and is used for bypass purposes in ultra-high-frequency applications. [ 1 ]

7. BNC connector - Wikipedia

   en.wikipedia.org/wiki/BNC_connector

   Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [ 9 ] using a special power or manual tool. [ 10 ] [ failed verification ] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are ...

8. Patch panel - Wikipedia

   en.wikipedia.org/wiki/Patch_panel

   However, switching equipment that can emulate the capabilities of a given patch bay is much more expensive. For example, an S-Video matrix routing switcher with the same capability (8×8) as a 16-point S-Video patch panel (8 patch cables connects 8 inputs and 8 outputs) may cost ten times more, though it would probably have more capabilities.

9. Through-hole technology - Wikipedia

   en.wikipedia.org/wiki/Through-hole_technology

   Through-hole (leaded) resistors. In electronics, through-hole technology (also spelled "thru-hole") is a manufacturing scheme in which leads on the components are inserted through holes drilled in printed circuit boards (PCB) and soldered to pads on the opposite side, either by manual assembly (hand placement) or by the use of automated insertion mount machines.