Search results
Results from the WOW.Com Content Network
A 16GB [1] DDR4 SO-DIMM module by Micron. DDR4 memory is supplied in 288-pin dual in-line memory modules (DIMMs), similar in size to 240-pin DDR3 DIMMs. DDR4 RAM modules feature pins that are spaced more closely at 0.85 mm compared to the 1.0 mm spacing in DDR3, allowing for a higher pin density within the same standard DIMM length of 133.35 mm ...
Assorted SO-DIMM Modules A 200-pin PC2-5300 DDR2 SO-DIMM. A 204-pin PC3-10600 DDR3 SO-DIMM. A SO-DIMM slot on a computer motherboard. A SO-DIMM (pronounced "so-dimm" / ˈ s oʊ d ɪ m /, also spelled "SODIMM") or small outline DIMM, is a smaller alternative to a DIMM, being roughly half the physical size of a regular DIMM. The first SODIMMs had ...
Modules are instead designed to run at different clock frequencies: for example, a PC-1600 module is designed to run at 100 MHz, and a PC-2100 is designed to run at 133 MHz. A module's clock speed designates the data rate at which it is guaranteed to perform, hence it is guaranteed to run at lower ( underclocking ) and can possibly run at ...
Normally, there is a performance penalty for using registered memory. Each read or write is buffered for one cycle between the memory bus and the DRAM, so the registered RAM can be thought of as running one clock cycle behind the equivalent unregistered DRAM.
PC133 is a computer memory standard defined by the JEDEC. PC133 refers to SDR SDRAM operating at a clock frequency of 133 MHz, on a 64-bit-wide bus, at a voltage of 3.3 V. PC133 is available in 168-pin DIMM and 144-pin SO-DIMM form factors. PC133 is the fastest and final SDR SDRAM standard ever approved by the JEDEC, and delivers a bandwidth of ...
A comparison of the standard (top) and low-profile UniDIMM version (bottom). The standard UniDIMM version has the same dimensions as DDR4 SO-DIMMs. [1]: 28 UniDIMM (short for Universal DIMM) is a specification for dual in-line memory modules (DIMMs), which are printed circuit boards (PCBs) designed to carry dynamic random-access memory (DRAM) chips
In a computer, the memory bank may be determined by the memory controller along with physical organization of the hardware memory slots. In a typical synchronous dynamic random-access memory (SDRAM) or double data rate SDRAM (DDR SDRAM), a bank consists of multiple rows and columns of storage units, and is usually spread out across several chips .
This led to MOSFETs eventually replacing magnetic cores as the standard storage elements in computer memory. [ 17 ] In 1965, J. Wood and R. Ball of the Royal Radar Establishment proposed digital storage systems that use CMOS (complementary MOS) memory cells, in addition to MOSFET power devices for the power supply , switched cross-coupling ...