Search results
Results from the WOW.Com Content Network
AEP meter label format follows ANSI C12.10 requirements for format of the electric meter labels. (See below) The format for the barcode label is: . AABYYYYYYYYYZZZZZ where AA is the meter test code B is an identifier for the meter manufacturer YYYYYYYYY is the manufacturer’s serial number or utility number ZZZZZ is user specified
The charge control consists of a pressure switch built into the cell, which disconnects the charging current when the internal cell pressure rises above a certain limit; usually 200 pounds per square inch (1.4 MPa) to 300 pounds per square inch (2.1 MPa). This prevents overcharging and damage to the cell.
An electrostatic fieldmeter, also called a static meter is a tool used in the static control industry. It is used for non-contact measurement of electrostatic charge on an object. It measures the force between the induced charges in a sensor and the charge present on the surface of an object.
CPT II codes are billed in the procedure code field, just as CPT Category I codes are billed. Because CPT II codes are not associated with any relative value, they are billed with a $0.00 billable charge amount. [10]
Standard battery nomenclature describes portable dry cell batteries that have physical dimensions and electrical characteristics interchangeable between manufacturers. The long history of disposable dry cells means that many manufacturer-specific and national standards were used to designate sizes, long before international standards were reached.
Capacitance meter: Measures the capacitance component Current clamp: Measures current without physical connection Curve tracer: Applies swept signals to a device and allows display of the response Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter: Measures the amount of energy ...
Canadian Classification of Health Interventions (CCI) (used in Canada. Replaced CCP.) [2] Current Dental Terminology (CDT); Healthcare Common Procedure Coding System (including Current Procedural Terminology) (for outpatient use; used in United States)
Charge carrier density, also known as carrier concentration, denotes the number of charge carriers per volume. In SI units, it is measured in m −3. As with any density, in principle it can depend on position. However, usually carrier concentration is given as a single number, and represents the average carrier density over the whole material.