Ad
related to: offset rods in surveying tools
Search results
Results from the WOW.Com Content Network
Ranging rods of greater length, e.g. 3 to 6 m, are called ranging or range poles, and are used for very long survey lines. [3] Another type of ranging rod is known as an offset rod, which has no flag at the top. It is used for measuring small offsets from the survey line when the work is of an ordinary nature. [4]
Topographer's rods are special purpose rods used in topographical surveys. The rod has the zero mark at mid-height and the graduations increase in both directions away from the mid-height. In use, the rod is adjusted so that the zero point is level with the instrument (or the surveyor's eye if he is using a hand level for low-resolution work).
Surveying equipment, such as levels and theodolites, are used for accurate measurement of angular deviation, horizontal, vertical and slope distances. With computerisation, electronic distance measurement (EDM) , total stations , GNSS surveying and laser scanning have supplemented (and to a large extent supplanted) the traditional optical ...
The rod, perch, or pole (sometimes also lug) is a surveyor's tool [1] and unit of length of various historical definitions. In British imperial and US customary units, it is defined as 16 + 1 ⁄ 2 feet, equal to exactly 1 ⁄ 320 of a mile, or 5 + 1 ⁄ 2 yards (a quarter of a surveyor's chain), and is exactly 5.0292 meters.
in surveying (and scientific fields that use surveying techniques, such as geology and ecology) for a vertical rod that penetrates or sits on the ground and supports a compass or other instrument. The simplest use of a Jacob's staff is to make qualitative judgements of the height and angle of an object relative to the user of the staff.
Groma (surveying) Laser scanning; Level; Level staff; Measuring tape; Plane table; Pole (surveying) Prism (surveying) (corner cube retroreflector) Prismatic compass (angle measurement) Ramsden surveying instruments; Ranging rod; Surveyor's chain; Surveyor's compass; Tachymeter (surveying) Tape (surveying) Tellurometer; Theodolite. Half ...
An Ordnance Survey cut mark in the UK Occasionally a non-vertical face, and a slightly different mark, was used. The term benchmark, bench mark, or survey benchmark originates from the chiseled horizontal marks that surveyors made in stone structures, into which an angle iron could be placed to form a "bench" for a leveling rod, thus ensuring that a leveling rod could be accurately ...
The level must be horizontal to get a valid measurement. Because of this, if the horizontal crosshair of the instrument is lower than the base of the rod, the surveyor will not be able to sight the rod and get a reading. The rod can usually be raised up to 25 feet high, allowing the level to be set much higher than the base of the rod.
Ad
related to: offset rods in surveying tools