Search results
Results from the WOW.Com Content Network
The heating value (or energy value or calorific value) of a substance, usually a fuel or food (see food energy), is the amount of heat released during the combustion of a specified amount of it. The calorific value is the total energy released as heat when a substance undergoes complete combustion with oxygen under standard conditions .
A 1 inch tall uranium fuel pellet is equivalent to about 1 ton of coal, 120 gallons of crude oil, or 17,000 cubic feet of natural gas. [15] In light-water reactors , 1 kg of natural uranium – following a corresponding enrichment and used for power generation– is equivalent to the energy content of nearly 10,000 kg of mineral oil or 14,000 ...
The EN 590 had been introduced along with the European emission standards.With each of its revisions the EN 590 had been adapted to lower the sulphur content of diesel fuel – since 2007 this is called ultra-low-sulphur diesel as the former function of sulphur as a lubricant is absent (and needs to be replaced by additives).
Emulsified fuels are a type of emulsion that combines water with a combustible liquid, such as oil or fuel. An emulsion is a specialized form of dispersion that contains both a continuous phase and a dispersed phase. The most commonly utilized emulsified fuel is a water-in-diesel emulsion (also known as hydrodiesel). [1]
To express the efficiency of a generator or power plant as a percentage, invert the value if dimensionless notation or same unit are used. For example: A heat rate value of 5 gives an efficiency factor of 20%. A heat rate value of 2 kWh/kWh gives an efficiency factor of 50%. A heat rate value of 4 MJ/MJ gives an efficiency factor of 25%.
Gross heating value accounts for water in the exhaust leaving as vapor, and includes liquid water in the fuel prior to combustion. This value is important for fuels like wood or coal , which will usually contain some amount of water prior to burning.
A diesel cycle engine can be as much as 40% to 50% efficient at converting fuel into work, [2] where a typical automotive gasoline engine's efficiency is about 25% to 30%. [3] [4] In general, an engine is designed to run on a single fuel source and substituting one fuel for another may affect the thermal efficiency.
The Wobbe index is expressed in MJ/Nm³ (where 'Nm³' indicates'm³ in Normal conditions), or sometimes in BTU/scf.In the case of natural gas (molar mass 17 g/mol), the typical heating value is around 39 MJ/Nm³ (1,050 BTU/scf) and the specific gravity is approximately 0.59, giving a typical Wobbe index of 51 MJ/Nm³ (1,367 BTU/scf).