Search results
Results from the WOW.Com Content Network
The lateral width of the head restraint, measured at a point either 65 mm (2.56 in) below the top of the head restraint or 635 mm (25.0 in) above the seating reference point must be not less than 254 mm (10.0 in) for use with bench seats and 171 mm (6.73 in) for use with individual seats.
1969 Corvette Stingray coupe with T-top panels removed. The third-generation Corvette, patterned after the Mako Shark II concept car, was introduced for the 1968 model year and was in production until 1982. C3 coupes featured the first use of T-top removable roof panels. It introduced monikers that were later revived, such as LT-1, ZR-1, Z07 ...
[1] Throughout his career as a professional race car driver and builder John Greenwood successfully piloted Chevrolet Corvettes in several significant races in the 1970s, including the 24 Hours of Le Mans (1972, 1973, 1976), the 24 Hours of Daytona (1971), and the 12 Hours of Sebring (1971). [2] [3] [4]
The plant closed on August 7, 1986, its future essentially sealed when GM closed the Caprice/Impala assembly on August 1, 1980 and began developing a new factory, Wentzville Assembly — a then-state of the art, 3.7 million square foot plant on 569 acres approximately 40 miles (64 km) west of St. Louis, just off of I-70.
The 1959 Corvette Sting Ray concept and 1960 XP-700 show car in the front and the 1963 Corvette convertible and fastback in the back. The 1963 Sting Ray production car's lineage can be traced to two separate GM projects: the Q-Corvette, and Bill Mitchell's racing Sting Ray.
The National Corvette Museum showcases the Chevrolet Corvette, an American sports car that has been in production since 1953. It is located in Bowling Green, Kentucky , off Interstate 65 's Exit 28 and near General Motors ' Bowling Green Assembly Plant , where Corvettes are manufactured.
For the 8th generation (C8), the ZR1 was again on offer as the top variant for 2025, but major changes had been made to the car, not the least of which was to the Corvette layout, switching from a front mid-engine, rear-wheel-drive layout (FMR) to a rear mid-engine, rear-wheel-drive layout (RMR), moving the engine to the rear for the first time ...
The XP-897GT 2-rotor Concept was sold to Tom Falconer and fitted with a Mazda 13B rotary engine in 1997. In 1976, the 4-rotor engine was replaced by a 400 cu in (6,600 cc) Chevrolet V8, and the concept car was named Aerovette and approved for production for 1980.