Search results
Results from the WOW.Com Content Network
The starter kits advertise the ability to change the motor, wheels, tires, trim kit, springs/shocks, and bearings (From nylon bushings to steel bearings), add lighting kits, and, in some generations, swap the crystal to allow the cars to operate on multiple frequencies. Tutorials for modifications are also available on various XMODS forum sites.
Van Diemen RF01 Racing Car Suspension. Suspension is the system of tires, tire air, springs, shock absorbers and linkages that connects a vehicle to its wheels and allows relative motion between the two. [1] Suspension systems must support both road holding/handling and ride quality, [2] which are at odds with each other. The tuning of ...
Roll stiffness: By fitting springs with a higher spring rate, roll stiffness can be increased. Likewise, a lower spring rate results in increased roll. Ride height: By using threaded spring seats or threaded bottom brackets, [10] the ride height of the vehicle can be raised or lowered. The bottom mount is a threaded sleeve with two adjuster ...
Miniature oil-filled Coilover shock components for scale cars. A shock absorber or damper is a mechanical or hydraulic device designed to absorb and damp shock impulses. It does this by converting the kinetic energy of the shock into another form of energy (typically heat) which is then dissipated.
In many racing cars, the springs and dampers are relocated inside the bodywork. The suspension uses a bellcrank to transfer the forces at the knuckle end of the suspension to the internal spring and damper. This is then known as a "push rod" if bump travel "pushes" on the rod (and subsequently the rod must be joined to the bottom of the upright ...
Friction disc shock absorbers or André Hartford dampers were an early form of shock absorber or damper used for car suspension. They were commonly used in the 1930s but were considered obsolete post-war. [1] Compared to modern shock absorbers friction dampers only provided limited shock absorption but served mainly to damp down oscillation.
National Organization for Racing Radio Controlled Autos (NORRCA) was one of two premier sanctioning bodies for radio-controlled racing in North America along with Remotely Operated Auto Racers (ROAR) [1] [2] and at the time, the largest [3] boasting of 14,000 members according to the Los Angeles Times in 1994, despite a decline in participation by 40%. [4]
Despite the drawbacks, the MacPherson strut set-up is still used on some high performance cars, because they tend to have relatively small suspension travel, and so do not have the same kinematic problems. Up until the 1989 model year (964), Porsche 911 used a similar strut design that did not have coil springs, using torsion bar suspension ...