Search results
Results from the WOW.Com Content Network
Where t is the solidification time, V is the volume of the casting, A is the surface area of the casting that contacts the mold, n is a constant, [clarification needed] and B is the mold constant. This relationship can be expressed more simply as: = Where the modulus M is the ratio of the casting's volume to its surface area:
Mixed liquor suspended solids (MLSS) is the concentration of suspended solids, in an aeration tank during the activated sludge process, which occurs during the treatment of waste water. The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to ...
Sludge Volume Index (SVI) is a process control parameter used to describe the settling characteristics of sludge in the aeration tank of an activated sludge process. [1] It was introduced by Mohlman in 1934 and has become one of the standard measures of the physical characteristics of activated sludge processes.
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
The RBC process allows the wastewater to come in contact with a biological film in order to remove pollutants in the wastewater before discharge of the treated wastewater to the environment, usually a body of water (river, lake or ocean). A rotating biological contactor is a type of secondary (biological) treatment process.
The mold that made Andrea Smith sick first showed up on her bathroom ceiling, she said, and then appeared on her kitchen ceiling. After calling code enforcement about it, she said her landlord ...
MFI Measuring device. The Melt Flow Index (MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer.It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures.
The driving force shown here as ' ' is expressed in units of moles per unit of volume, but in some cases the driving force is represented by other measures of concentration with different units. For example, the driving force may be partial pressures when dealing with mass transfer in a gas phase and thus use units of pressure.