Search results
Results from the WOW.Com Content Network
The original list of IPv4 address blocks was published in September 1981. [3] In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr.
Host Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576 ...
Used for local communications within a private network [8] 100.64.0.0/10 100.64.0.0–100.127.255.255 4 194 304: Private network Shared address space [9] for communications between a service provider and its subscribers when using a carrier-grade NAT: 127.0.0.0/8 127.0.0.0–127.255.255.255 16 777 216: Host Used for loopback addresses to the ...
By default, each computer's Avahi daemon will respond to mDNS hostname.local queries, and most shell commands and application program calls that attempt to resolve such names are routed to that daemon by the default hosts: line in the Name Service Switch configuration file. It is also possible to configure the nss-mdns modules and Avahi to ...
A special case of private link-local addresses is the loopback interface. These addresses are private and link-local by definition since packets never leave the host device. IPv4 reserves the entire class A address block 127.0.0.0 / 8 for use as private loopback addresses. IPv6 reserves the single address ::1.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic.
That means any packet sent to any of those addresses is looped back. The address 127.0.0.1 is the standard address for IPv4 loopback traffic; the rest are not supported by all operating systems. However, they can be used to set up multiple server applications on the host, all listening on the same port number.