Search results
Results from the WOW.Com Content Network
A simple example of an effectively random cause in a physical system is a borderline electrical connection in the wiring or a component of a circuit, where (cause 1, the cause that must be identified and rectified) two conductors may touch subject to (cause 2, which need not be identified) a minor change in temperature, vibration, orientation ...
Its CPU time "usage" is a measure of how much CPU time is not being used by other threads. In Windows 2000 and later the threads in the System Idle Process are also used to implement CPU power saving. The exact power saving scheme depends on the operating system version and on the hardware and firmware capabilities of the system in question.
The message body that follows is by default an XML message and can contain a number of separate response codes, depending on how many sub-requests were made. [7] 208 Already Reported (WebDAV; RFC 5842) The members of a DAV binding have already been enumerated in a preceding part of the (multistatus) response, and are not being included again.
If the delivery failure message says the account doesn't exist double check the spelling of the address you entered. A single misplaced letter could cause a delivery failure. If the message keeps getting bounced back, make sure the account is closed or hasn't been moved.
C: This is a test message with 5 header fields and 4 lines in the message body. C: Your friend, C: Bob C: . S: 250 Ok: queued as 12345 C: QUIT S: 221 Bye {The server closes the connection} And below is an example of an SMTP connection in which the SMTP Server supports the Enhanced Status Code, taken from RFC 2034:
If the user has enabled it, the system will also write an entry to the system event log. The log entry contains information about the bug check (including the bug check code and its parameters) as well as a link that will report the bug and provide the user with prescriptive suggestions if the cause of the check is definitive and well-known.
There is also a network message heard when an attempt to route a call to a nodal or ISDN T1 on the terminating end fails due to no call set-up signal from the PBX being received by the far-end Tandem or edge switch "Your call did not go through, [TANDEM]". The tandem IDs are formatted like this: [3 digit number]T for main tandems [AREA-CODE ...
In telecommunication, supervision is the monitoring of a telecommunication circuit for telephony to convey to an operator, user, or a switching system, information about the operational state of the circuit. The typical operational states of trunks and lines are the idle and busy states, seizure, and disconnect. [1]