Search results
Results from the WOW.Com Content Network
Endobronchial valves are medical devices that allow air to exit these sections but not to re-enter. The valves, in effect, cause damaged lung tissue to deflate, thereby reducing the excessive lung volume (hyperinflation) caused by emphysema. Two endobronchial valves have been approved by the FDA for BLVR: Zephyr and Spiration. [citation needed]
An intravasal control valve is a reversible valve implanted in the vas deferens with the ability to either inhibit or permit sperm passage depending on the position of the device. Bionyx has developed a T-shaped intravasal control valve composed of gold and stainless steel for use in humans. [ 5 ]
Adjusting is the final setting of balancing devices such as dampers and valves, adjusting fan speeds and pump impeller sizes, in addition to automatic control devices such as thermostats and pressure controllers to achieve maximum specified system performance and efficiency during normal operation.
The valves are in-line and use straight six-bolt valve covers. Coolant is routed out of the block through the intake manifold. The design was soon bored to 260 cu in (4.3 L) and again to 289 cu in (4.7 L), then stroked to 302 cu in (4.9 L), settling on the most common displacement offered until the engine's retirement in 2001, nearly 40 years ...
With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in drawing in the fresh charge. Engine designers ...
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).
Reversing valves are built into the heat pump by the manufacturer, and must be replaced by an HVAC technician if they fail. Since the valve is an integral part of the sealed refrigerant circuit, proper procedures for recovering and then later refilling the refrigerant must be followed, to prevent its loss into the atmosphere.