Ad
related to: usb microphone with headphone jack
Search results
Results from the WOW.Com Content Network
The USB Type-C Cable and Connector Specification specifies a mapping from a USB-C jack to a 4-pole TRRS jack, for the use of headsets, and supports both CTIA and OMTP (YD/T 1885–2009) modes. [78] Some devices transparently handle many jack standards, [79] [80] and there are hardware implementations of this available as components. [81]
General 3.5 mm computer headsets come with two 3.5 mm connectors: one connecting to the microphone jack and one connecting to the headphone/speaker jack of the computer. 3.5 mm computer headsets connect to the computer via a sound card, which converts the digital signal of the computer to an analog signal for the headset. USB computer headsets ...
Two pins are used for the mono headphone signal and two pins for the unbalanced microphone signal. The 4-pin XLR connector is also commonly used on amateur radio microphones, but transferring unbalanced audio instead, and using the 4th pin (with the common ground) for a push-to-talk (PTT) circuit activated by a button on the microphone.
Nevertheless, the MIC and AGND pins must have automatic swap capability, for two reasons: firstly, the USB-C plug may be inserted either side; secondly, there is no agreement, which TRRS rings shall be GND and MIC, so devices equipped with a headphone jack with microphone input must be able to perform this swap anyway. [67]
A phone connector (tip, ring, sleeve) also called an audio jack, phone plug, jack plug, stereo plug, mini-jack, or mini-stereo. This includes the original 6.35 mm (quarter inch) jack and the more recent 3.5 mm (miniature or 1/8 inch) and 2.5 mm (subminiature) jacks, both mono and stereo versions. There also exists 4.4 mm Pentaconn connectors.
An audio interface is a piece of computer hardware that allows the input and output of audio signals to and from a host computer or recording device. Audio interfaces are closely related to computer sound cards , but whereas sound cards are optimized for audio playback an audio interface is primarily intended to provide low-latency analog-to ...
A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors , as described below. A Y-cable , Y cable , or splitter cable is a cable with three ends: one common end and two other ends.
Headphones that use cables typically have either a 1 ⁄ 4 inch (6.4 mm) or 1 ⁄ 8 inch (3.2 mm) phone jack for plugging the headphones into the audio source. Some headphones are wireless, using Bluetooth connectivity to receive the audio signal by radio waves from source devices like cellphones and digital players. [5]
Ad
related to: usb microphone with headphone jack