Search results
Results from the WOW.Com Content Network
An interrupt function to the host microprocessor. An on-chip FIFO buffer for both incoming and outgoing data; this gives the host system more time to respond to an interrupt generated by the UART, without loss of data. Both the computer hardware and software interface of the 16550 are backward compatible with the earlier 8250 UART and 16450 UART.
128-byte buffers. This UART can handle a maximum standard serial port speed of 921.6 kbit/s if the maximum interrupt latency is 1 millisecond. This UART supports 9-bit characters in addition to the 5- to 8-bit characters that other UARTs support. This was introduced by Oxford Semiconductor, which is now owned by PLX Technology.
Typical examples include RISC-V CPU which has a set of registers to handle interrupts, and UART which has a set of registers to handle data reception and transmission. References [ edit ]
The STM32 F7-series is a group of STM32 microcontrollers based on the ARM Cortex-M7F core. Many of the F7 series are pin-to-pin compatible with the STM32 F4-series. Core: ARM Cortex-M7F core at a maximum clock rate of 216 MHz. Many of STM32F76xxx and STM32F77xxx models have a digital filter for sigma-delta modulators (DFSDM) interface. [31]
processor status (servicing an interrupt, running in protected mode, etc.) condition codes (result of previous comparisons) Because special registers are closely tied to some special function or status of the microcontroller, they might not be directly writeable by normal instructions (such as adds, moves, etc.). Instead, some special registers ...
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
For the "interrupt acknowledge" method, the external device gives the CPU an interrupt handler number. The interrupt acknowledge method is used by the Intel Pentium and many older microprocessors. [8] When the CPU is affected by an interrupt, it looks up the interrupt handler in the interrupt vector table, and transfers control to it.
Examples include pen-down interrupts from touchscreen sensors, thermal limit alerts from temperature sensors, alarms issued by real-time clock chips, SDIO [note 8] and audio jack insertions for an audio codec. Interrupts to main may also be faked by using polling (similarly to USB 1.1 and 2.0).