Search results
Results from the WOW.Com Content Network
KryoFlux reads "flux transitions" from floppy disks at a very fine resolution. [6] It can also read disks originally written with different bit cell widths and drive speeds, with a normal fixed-speed drive. [7] The software is available for Microsoft Windows, [8] Mac OS and Linux. The KryoFlux controller plugs into a standard USB port, and ...
These cables still only supported two drives, one before and one after the twist, but they allowed using one cable for any combination of drives with differing connectors. This type of cable is called a universal cable. [8] When multiple floppy disks are connected, many pins are shared, including the read and write data pins.
The 1541Ultimate-II emulates a 1541 disk drive for Commodore computers on a cartridge, using MicroSD or USB disks to store virtual floppy disks. The disk can be downloaded through fast, but not fully compatible proprietary disk emulation. Disk connector for fully compatibility is integrated, but not yet supported in software (as for the 1541U-I ...
The floppy disk emulator can provide other systems access to the data on the emulated floppy in a number of ways: Direct access to some dedicated disk partition (e.g.: a 1.44MB partition on a USB key) Floppy file system translation (e.g.: FAT12 floppy ↔ USB key folder) Floppy disk images (e.g.: raw floppy ↔ .img/.iso USB key file)
The FD-4000 drive had the advantage of being able to read hard-to-find enhanced floppy disks and could be formatted to hold 3.2 MB of data. In addition, the FD series drives could partition floppy disks to emulate the 1541, 1571 and 1581 disk format (although unfortunately, not the emulated drive firmware), and a real time clock module could be ...
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
An internal floppy drive and controller are required as well; USB floppy drives operate strictly at the file system level and do not allow low-level disk access. [9] The WD1770 controller chip, however, was the seat of some early problems with 1581 drives when the first production runs were recalled due to a high failure rate; the problem was ...
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...