enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Point-to-point construction - Wikipedia

   en.wikipedia.org/wiki/Point-to-point_construction

   Terminal strip construction, which is often referred to as point-to-point construction within the tube guitar amplifier community, uses terminal strips (also called "tag boards"). A terminal strip has stamped tin-plated copper terminals, each with a hole through which wire ends could be pushed, fitted on an insulating strip, usually made of a ...

3. Terminal (electronics) - Wikipedia

   en.wikipedia.org/wiki/Terminal_(electronics)

   Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.

4. Breadboard - Wikipedia

   en.wikipedia.org/wiki/Breadboard

   The main areas, to hold most of the electronic components, are called terminal strips. In the middle of a terminal strip of a breadboard, one typically finds a notch running in parallel to the long side. The notch is to mark the centerline of the terminal strip and provides limited airflow (cooling) to DIP ICs straddling the centerline ...

5. List of electronic component packaging types - Wikipedia

   en.wikipedia.org/wiki/List_of_electronic...

   Low-profile fine-pitch ball grid array : A square or rectangular array of solder balls on one surface, ball spacing typically 0.8 mm; Micro ball grid array : Ball spacing less than 1 mm; Thin fine-pitch ball grid array : A square or rectangular array of solder balls on one surface, ball spacing typically 0.5 mm

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Terminal blocks (also called terminal boards or strips) provide a convenient means of connecting individual electrical wires without a splice or physically joining the ends. Since terminal blocks are readily available for a wide range of wire sizes and terminal quantity, they are one of the most flexible types of electrical connector available.

7. Perfboard - Wikipedia

   en.wikipedia.org/wiki/Perfboard

   Top of a copper clad Perfboard with solder pads for each hole. Perfboard is a material for prototyping electronic circuits.It is a thin, rigid sheet with holes pre-drilled at standard intervals across a grid, usually a square grid of 0.1 inches (2.54 mm) spacing.