Search results
Results from the WOW.Com Content Network
The standard defines the "A", "B" and "C" series of paper sizes, which includes the A4, the most commonly available paper size worldwide. Two supplementary standards, ISO 217 and ISO 269 , define related paper sizes; the ISO 269 " C " series is commonly listed alongside the A and B sizes.
Australia uses metric paper sizes for office use and home printing (most commonly A4 size, being 210 × 297 mm) [49] However, the term dots per inch (dpi) is still used when referring to printing resolution. [50] The photo printing industry uses both imperial and metric sizes for photograph dimensions (e.g. 4 × 6 inches as well as 10 × 15 cm).
Video standards associated with IBM-PC-descended personal computers are shown in the diagram and table below, alongside those of early Macintosh and other makes for comparison. (From the early 1990s onwards, most manufacturers moved over to PC display standards thanks to widely available and affordable hardware). Comparison of video resolutions.
The Australian state of Victoria requires its residents to register their motor vehicles and display vehicle registration plates. [1] Current regular issue plates are to the standard Australian dimensions of 372 mm (14.6 in) in length by 134 mm (5.3 in) in height, but Victoria has used its own serial dies since 1977.
The international paper size standard is ISO 216. It is based on the German DIN 476 standard for paper sizes. Each ISO paper size is one half of the area of the next larger size in the same series. ISO paper sizes are all based on a single aspect ratio of the square root of 2, or approximately 1:1.41421. There are different series, as well as ...
Australasian standard three pin plug, with part insulation on the Active/Line and Neutral pins. AS/NZS 3112 is the harmonised/joint Australian and New Zealand Standard for AC power plugs (male) and sockets (female). The standard is used in Australia, New Zealand, Fiji, Tonga, Solomon Islands, Papua New Guinea and several other Pacific island ...
An analysis of the price of a standards document to an end user, was that 40% was ascribed to the cost of sending the PDF document, [5] 54% was a royalty payable to the distributor (SAI Global), and 6% was a royalty to the IP owner (Standards Australia). [5] The price of standards document in Australia has been seen, by some industry observers ...
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".