enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB communications - Wikipedia

   en.wikipedia.org/wiki/USB_communications

   All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x.

3. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   The Hi-Speed USB logo. USB 2.0 was released in April 2000, adding a higher maximum signaling rate of 480 Mbit/s (maximum theoretical data throughput 53 MByte/s [25]) named High Speed or High Bandwidth, in addition to the USB 1.x Full Speed signaling rate of 12 Mbit/s (maximum theoretical data throughput 1.2 MByte/s). [26]

4. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   Another factor reducing throughput is deliberate policy decisions made by Internet service providers that are made for ... 1.2/0.075 kbit/s: ... USB 2.0 high speed:

5. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   USB 2.0 provides for a maximum cable length of 5 metres (16 ft 5 in) for devices running at high speed (480 Mbit/s). The primary reason for this limit is the maximum allowed round-trip delay of about 1.5 μs. If USB host commands are unanswered by the USB device within the allowed time, the host considers the command lost.

6. USB 3.0 - Wikipedia

   en.wikipedia.org/wiki/USB_3.0

   In USB 3.0, dual-bus architecture is used to allow both USB 2.0 (Full Speed, Low Speed, or High Speed) and USB 3.0 (SuperSpeed) operations to take place simultaneously, thus providing backward compatibility. The structural topology is the same, consisting of a tiered star topology with a root hub at level 0 and hubs at lower levels to provide ...

7. USB hub - Wikipedia

   en.wikipedia.org/wiki/USB_hub

   To allow high-speed (USB 2.0) devices to operate in their fastest mode, all hubs between the devices and the computer must be high-speed. High-speed devices should fall back to full-speed (USB 1.1) when plugged into a full-speed hub (or connected to an older full-speed computer port). While high-speed hubs can communicate at all device speeds ...