Search results
Results from the WOW.Com Content Network
Dimmer light switch with RF-based remote control [1] A wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture: [2]
A thyristor dimmer rack An electrical schematic for a typical SCR-based light dimmer Solid-state , or semiconductor , dimmers were introduced to solve some of these problems. Semiconductor dimmers switch on at an adjustable time (phase angle) after the start of each alternating-current half-cycle, thereby altering the voltage waveform applied ...
Some examples of actions that can be achieved without a hub or controller would be: timed shutoff of a bathroom fan (timer plug-in module or a switch with timer feature built-in), lights turning on or off based on a photocell's sensing of sunlight (I/O plug-in module), turning on one set of lights with a single tap of the switch and turning on ...
Electric motors; 32 return 31 33 main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g 3. slow rpm 33h 4. slow rpm 33L rotation left 30L 33R rotation right 30R Indicators 49 flasher unit in 15, 15+, 15/54, +, +15, X 49a flasher unit out, indicator switch in 54L, S, S4, L 49b out 2. flasher circuit 49c
Many older appliance units have a 'local control' feature whereby the relay is intentionally bypassed with a high value resistor; the module can then sense the appliance's own switch and turn on the relay when the local switch is operated. This sense current may be incompatible with LED or CFL lamps. Not all devices can be used on a dimmer.
The process uses a remote gate control and is illustrated in Figure 7. As current flows from the p-layer under the gate into the n-layer under MT1, minority carriers in the form of free electrons are injected into the p-region and some of them are collected by the underlying n-p junction and pass into the adjoining n-region without recombining.
A high-voltage disconnect switch used in an electrical substation. Such switches are used mostly to isolate circuits, and usually cannot break load current. High-voltage switches are available for the highest transmission voltages, up to 1 million volts. This switch is gang-operated so that all three phases are interrupted at the same time.
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...