Ads
related to: truss layout design sheet
Search results
Results from the WOW.Com Content Network
Timber roof truss example. The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs.In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam.
English: Detail of a steel truss, like it is build nowadays, it uses welds and bolds due to the fact it is at site joint, where two parts get connected at site (see Plan of the tuss). It is a part of a Plan (File:Det JoKa008-Model.pdf), which shows three details of a truss (File:Fachwerkplan.pdf)
Lenticular trusses, patented in 1878 by William Douglas (although the Gaunless Bridge of 1823 was the first of the type), have the top and bottom chords of the truss arched, forming a lens shape. A lenticular pony truss bridge is a bridge design that involves a lenticular truss extending above and below the roadbed.
Gable (ridged, dual-pitched, peaked, saddle, pack-saddle, saddleback, [5] span roof [6]): A simple roof design shaped like an inverted V. Cross gabled: The result of joining two or more gabled roof sections together, forming a T or L shape for the simplest forms, or any number of more complex shapes.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
A truss roof with tongue and groove sheathing. The gap in the sheathing at the ridge is the space designed to allow natural ventilation. Pre-manufactured roof trusses come in a wide variety of styles. They are designed by the manufacturer for each specific building. Timber trusses also are built in a variety of styles using wood or metal joints.
Interior of a barn with a Fink truss, with the characteristic W shape. Fink design trusses are used today for pedestrian bridges and as roof trusses in building construction in an inverted (upside down) form where the lower chord is present and a central upward projecting vertical member and attached diagonals provide the bases for roofing. [9]
The structural system of a high-rise building is designed to cope with vertical gravity loads as well as lateral loads caused by wind or seismic activity. The structural system consists only of the members designed to carry the loads, and all other members are referred to as non-structural.
Ads
related to: truss layout design sheet