enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Anti-roll bar - Wikipedia

   en.wikipedia.org/wiki/Anti-roll_bar

   An anti-roll bar (roll bar, anti-sway bar, sway bar, stabilizer bar) is an automobile suspension part that helps reduce the body roll of a vehicle during fast cornering or over road irregularities. It links opposite front or rear wheels to a torsion spring using short lever arms for anchors. This increases the suspension's roll stiffness—its ...

3. Suspension link - Wikipedia

   en.wikipedia.org/wiki/Suspension_link

   These links work in tandem with the coil springs, dampers, and sway bar to control all six degrees of freedom of the axle. The upper links (orange) and the lower links (yellow) work in tandem to control the pitch, yaw and the fore and aft movement (surge). The panhard rod (green) controls the left and right movement (sway). While the springs ...

4. Trailing-arm suspension - Wikipedia

   en.wikipedia.org/wiki/Trailing-arm_suspension

   Trailing-arm designs in live axle setups often use just two or three links and a Panhard rod to locate the wheel laterally. A trailing arm design can also be used in an independent suspension arrangement. Each wheel hub is located only by a large, roughly triangular arm that pivots at one point, ahead of the wheel. Seen from the side, this arm ...

5. Unsafe at Any Speed: The Designed-In Dangers of the American ...

   en.wikipedia.org/wiki/Unsafe_at_Any_Speed:_The...

   George Caramagna, a mechanic working on the suspension system, suggested installing a stabilizer (anti-roll or "anti-sway") bar, but was overruled by GM management. [citation needed] To make up for the cost-cutting lack of a front stabilizer bar, Corvairs required tire pressures which were outside of the tire manufacturers' recommended tolerances.

6. Multi-link suspension - Wikipedia

   en.wikipedia.org/wiki/Multi-link_suspension

   A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]

7. “Rust” Director Who Survived Bullet Wound Says Resuming ...

   www.aol.com/rust-director-survived-bullet-wound...

   When asked if he noticed any change in Baldwin's approach to his performance in the movie when filming resumed, Souza added, "It was tough for him, you know.