Search results
Results from the WOW.Com Content Network
Acrylonitrile butadiene styrene (ABS) (chemical formula (C 8 H 8) x · (C 4 H 6) y · (C 3 H 3 N) z) is a common thermoplastic polymer. Its glass transition temperature is approximately 105 °C (221 °F). [4] ABS is amorphous and therefore has no true melting point. ABS is a terpolymer made by polymerizing styrene and acrylonitrile in the ...
The characterization of mechanical properties in polymers typically refers to a measure of the strength, elasticity, viscoelasticity, and anisotropy of a polymeric material. The mechanical properties of a polymer are strongly dependent upon the Van der Waals interactions of the polymer chains, and the ability of the chains to elongate and align ...
Draft angle design is an important factor when designing plastic parts. Because of shrinkage of plastic material, injection molded parts have a tendency to shrink onto a core. This creates higher contact pressure on the core surface and increases friction between the core and the part, thus making ejection of the part from the mold difficult.
ASA has lower glass transition temperature than ABS, 100 °C vs 105 °C, providing better low-temperature properties to the material. [3] ASA has high outdoor weatherability; it retains gloss, color, and mechanical properties in outdoor exposure. It has good chemical and heat resistance, high gloss, good antistatic properties, and is tough and ...
A material property is an intensive property of a material, i.e., a physical property or chemical property that does not depend on the amount of the material. These quantitative properties may be used as a metric by which the benefits of one material versus another can be compared, thereby aiding in materials selection.
Copolymerization is used to modify the properties of manufactured plastics to meet specific needs, for example to reduce crystallinity, modify glass transition temperature, control wetting properties or to improve solubility. [43] It is a way of improving mechanical properties, in a technique known as rubber toughening. Elastomeric phases ...
Mixing these together can give a material with inconsistent properties, which can be unappealing to industry. For example, mixing different colored plastics with different plastic colorants together can produce a discolored or brown material and for this reason plastic is usually sorted by both polymer type and color before recycling. [6]
As done in crystalline materials, particles can be added to semi-crystalline polymers to change the mechanical properties. In crystalline materials the addition of particles works to impede dislocation motion and strengthen the material. However, for many semi-crystalline polymers particle fillers weaken the material.