Search results
Results from the WOW.Com Content Network
A mobile phone signal (also known as reception and service) is the signal strength (measured in dBm) received by a mobile phone from a cellular network (on the downlink). Depending on various factors, such as proximity to a tower, any obstructions such as buildings or trees, etc. this signal strength will vary. Most mobile devices use a set of ...
For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu). Examples. 100 dBμ or 100 mV/m: blanketing interference may occur on some receivers
−73 dBm: 50.12 pW "S9" signal strength, a strong signal, on the S meter of a typical ham or shortwave radio receiver: −80 dBm: 10 pW: −100 dBm: 0.1 pW: Minimal received signal power of wireless network (802.11 variants) −111 dBm: 0.008 pW = 8 fW: Thermal noise floor for commercial GPS single-channel signal bandwidth (2 MHz) −127.5 dBm ...
In 3G, the most prevalent technology was UMTS with CDMA-2000 in close contention. All radio access technologies have to solve the same problems: to divide the finite RF spectrum among multiple users as efficiently as possible. GSM uses TDMA and FDMA for user and cell separation. UMTS, IS-95 and CDMA-2000 use CDMA. WiMAX and LTE use OFDM.
Cellular signal strength of -74dBm (or 66 asu) displayed on a smartphone.Also shown: signal bars of two cellular networks, and signal bars of a Wi-Fi network. In telecommunications, received signal strength indicator or received signal strength indication [1] (RSSI) is a measurement of the power present in a received radio signal.
CDMA2000 is a family of 3G mobile technology standards for sending voice, data, and signaling data between mobile phones and cell sites. It is a backwards-compatible successor to second-generation cdmaOne (IS-95) set of standards and used especially in North America and South Korea, China, Japan, Australia and New Zealand.
The dBm is an absolute reference level measurement (see Decibel § Suffixes and reference values) with respect to 1 mW power. When the nominal signal power is 0 dBm at the TLP, the test point is called a zero transmission level point, or zero-dBm TLP. The abbreviation dBm0 stands for the power in dBm measured
In telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the CNR of the radio frequency passband signal from the SNR of an analog base band message signal after demodulation. For example, with FM radio, the strength of the 100 MHz ...