Search results
Results from the WOW.Com Content Network
The heating value depends on the source of gas that is used and the process that is used to liquefy the gas. The range of heating value can span ±10 to 15 percent. A typical value of the higher heating value of LNG is approximately 50 MJ/kg or 21,500 BTU/lb. [2] A typical value of the lower heating value of LNG is 45 MJ/kg or 19,350 BTU/lb.
LNG: 0.0829 WEL: 0.083 3 Li lithium; use: 136 LNG: 147.1 ... Values refer to the enthalpy change in the conversion of liquid to gas at the boiling point (normal, 101. ...
The boiling point corresponds to the temperature at which the vapor pressure of the liquid equals the surrounding environmental pressure. Thus, the boiling point is dependent on the pressure. Boiling points may be published with respect to the NIST, USA standard pressure of 101.325 kPa (1 atm), or the IUPAC standard pressure of 100.000 kPa (1 ...
Lee [4] developed a modified form of the Antoine equation that allows for calculating vapor pressure across the entire temperature range using the acentric factor (𝜔) of a substance. The fundamental structure of the equation is based on the van der Waals equation and builds upon the findings of Wall [ 5 ] and Gutmann et al. [ 6 ] , who ...
Boiling-point diagram. The preceding equilibrium equations are typically applied for each phase (liquid or vapor) individually, but the result can be plotted in a single diagram. In a binary boiling-point diagram, temperature (T ) (or sometimes pressure) is graphed vs. x 1. At any given temperature (or pressure) where both phases are present ...
At ambient pressure the boiling point of liquefied helium is 4.22 K (−268.93 °C). Below 2.17 K liquid 4 He becomes a superfluid (Nobel Prize 1978, Pyotr Kapitsa) and shows characteristic properties such as heat conduction through second sound, zero viscosity and the fountain effect among others.
The correct result would be P = 101.325 kPa, the normal (atmospheric) pressure. The deviation is −1.63 kPa or −1.61 %. The deviation is −1.63 kPa or −1.61 %. It is important to use the same absolute units for T and T c as well as for P and P c .
This is a list of the various reported boiling points for the elements, with recommended values to be used elsewhere on Wikipedia. ... all values refer to the normal ...