Ads
related to: lot size to acreage calculator for property
Search results
Results from the WOW.Com Content Network
Floor area ratio (FAR) is the ratio of a building's total floor area (gross floor area) to the size of the piece of land upon which it is built. It is often used as one of the regulations in city planning along with the building-to-land ratio. [1] The terms can also refer to limits imposed on such a ratio through zoning.
A quarter section is 160 acres (65 ha) and a "quarter-quarter section" is 40 acres (16 ha). In 1832 the smallest area of land that could be acquired was reduced to the 40-acre (16 ha) quarter-quarter section, and this size parcel became entrenched in American mythology.
One acre equals 1 ⁄ 640 (0.0015625) square mile, 4,840 square yards, 43,560 square feet, [2] or about 4,047 square metres (0.4047 hectares) (see below).While all modern variants of the acre contain 4,840 square yards, there are alternative definitions of a yard, so the exact size of an acre depends upon the particular yard on which it is based.
The lot and block survey system is a method used in the United States and Canada to locate and identify land, particularly for lots in densely populated metropolitan areas, suburban areas and exurbs. It is sometimes referred to as the recorded plat survey system or the recorded map survey system .
A characteristic of the size of a lot is its area. The area is typically determined as if the land is flat and level, although the terrain of the lot may not be flat, i. e, the lot may be hilly. The contour surface area of the land is changeable and may be too complicated for determining a lot's area. Lots can come in various sizes and shapes.
Build-out applies land use or zoning assumptions about density to the available land area. The build-out calculation may deduct land due to physical constraints to development (e.g. sensitive natural resources), potential infrastructure dedications (e.g. streets, public open space, or stormwater management structures), and practical design considerations (e.g. lot layout inefficiencies).
The acre is also commonly used to measure land areas, where 1 acre = 4,840 square yards = 43,560 square feet. An acre is approximately 40% of a hectare. On the atomic scale, area is measured in units of barns, such that: [13] 1 barn = 10 −28 square meters. The barn is commonly used in describing the cross-sectional area of interaction in ...
In Arkansas and Missouri, the official conversion is 1 arpent = 0.8507 acres (3,443 square metres). [3] In Paris, the square arpent was 220 French feet × 220 French feet = 48,400 French square feet, about 5,107 square metres or 1.262 acres. In Mauritius and Seychelles, an arpent is about 4220.87 square metres, 0.4221 hectares, 1.043 acres. [4]
Ads
related to: lot size to acreage calculator for property