Search results
Results from the WOW.Com Content Network
Huygens' maintaining power in use. The weight drive used by Christiaan Huygens in his early clocks acts as a maintaining power. In this layout, the weight which drives the clock is carried on a pulley and the cord (or chain) supporting the weight is wrapped around the main driving wheel on one side and the rewinding wheel on the other.
[5] In 1815, Giuseppe Zamboni of Verona invented and showed another electrostatic clock run with dry pile batteries and an oscillating orb. His team produced improved clocks over many years, which were later denoted as "the most elegant and at the same time the most simple movement yet produced by the electric column". [6]
The Self Winding Clock Company (SWCC) was a major manufacturer of electromechanical clocks from 1886 until about 1970. [1] Based in New York City, the company was one of the first to power its clocks with an electric motor instead of winding by hand. A patented clock mechanism automatically rewinds the main spring each hour by the small ...
Currently, the clock is operated using a weight cable system with weights weighing 800 pounds and housed in a chute that runs through the courthouse. Historic courthouse clock to get new winding ...
4.5 + 4.5: H: 91.3 L: 65.1 W: 52.4 This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series. There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart.
After winding, the arbor is stationary and the pull of the mainspring turns the barrel, which has a ring of gear teeth around it. This meshes with one of the clock's gears, usually the center wheel pinion and drives the wheel train. The barrel usually rotates once every 8 hours, so the common 40-hour spring requires 5 turns to unwind completely.
A torsion pendulum clock, more commonly known as an anniversary clock or 400-day clock, is a mechanical clock which keeps time with a mechanism called a torsion pendulum. This is a weighted disk or wheel, often a decorative wheel with three or four chrome balls on ornate spokes, suspended by a thin wire or ribbon called a torsion spring (also ...
In striking clocks, the striking train is a gear train that moves a hammer to strike the hours on a gong. It is usually driven by a separate but identical power source to the going train. In antique clocks, to save costs, it was often identical to the going train, and mounted parallel to it on the left side when facing the front of the clock. [11]