enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Rebar - Wikipedia

    en.wikipedia.org/wiki/Rebar

    US/Imperial bar sizes give the diameter in units of 1 ⁄ 8 inch (3.2 mm) for bar sizes #2 through #8, so that #8 = 8 ⁄ 8 inch = 1-inch (25 mm) diameter. There are no fractional bar sizes in this system. The "#" symbol indicates the number sign, and thus "#6" is read as "number six". The use of the "#" sign is customary for US sizes, but "No ...

  3. Rebar detailing - Wikipedia

    en.wikipedia.org/wiki/Rebar_detailing

    Rebar detailing is the discipline of preparing 'shop/placing' or 'fabrication' drawings or shop drawings of steel reinforcement for construction. Engineers prepare 'design drawings' that develop required strengths by applying rebar size, spacing, location, and lap of steel .

  4. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  5. Anchorage in reinforced concrete - Wikipedia

    en.wikipedia.org/wiki/Anchorage_in_Reinforced...

    Because the actual bond stress varies along the length of a bar anchored in a zone of tension, most international codes of specifications [2] [3] [4] use the concept of development length rather than bond stress. The same concept applies to lap splice length mentioned in the codes where splices (overlapping) provided between two adjacent bars ...

  6. British Standard Pipe - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Pipe

    For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread. The taper is 1:16, meaning that for each 16 units of measurement increase in the distance from the end, the diameter increases by 1 unit of measurement.

  7. Netizens Reveal 33 Of The Weirdest Deliveries They’ve Ever ...

    www.aol.com/folks-order-bizarre-things-33...

    Image credits: Dwight Dunlop #5. When I was at school, a long time ago, I came home to find a new television in the lounge. I was pleased, but a little surprised that my parents hadn’t mentioned it.

  8. Box Office: ‘Kraven the Hunter’ Bombs With $11 Million ...

    www.aol.com/box-office-kraven-hunter-bombs...

    Despite the two newcomers, Disney’s “Moana 2” retained the No. 1 spot on domestic box office charts for the third consecutive weekend with $26.6 million from 4,000 theaters.

  9. Bar stock - Wikipedia

    en.wikipedia.org/wiki/Bar_stock

    Drill rod diameters range from 0.0135 to 1.5 in (0.34 to 38.10 mm); in the United States diameters smaller than 27 ⁄ 64 th of an inch (11 mm) are made in letter drill sizes and number drill sizes, in addition to fractional sizes. Lengths are usually one or three feet (0.3048 or 0.9144 m).