Ads
related to: tongue and groove boards exteriorebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Box houses (boxed house, box frame, [16] box and strip, [17] piano box, single-wall, board and batten, and many other names) have minimal framing in the corners and widely spaced in the exterior walls, but like the vertical plank wall houses, the vertical boards are structural. [18] The origins of boxed construction is unknown.
Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location
Tongue and groove: Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint: Also called a bird's beak cut, this joint used in roof construction. A V-shaped cut in the rafter connects the rafter to the wall-plate. [11 ...
Later, the boards were radially sawn in a type of sawmill called a clapboard mill, producing vertical-grain clapboards. The more commonly used boards in New England are vertical-grain boards. Depending on the diameter of the log, cuts are made from 4 + 1 ⁄ 2 to 6 + 1 ⁄ 2 inches (110 to 170 mm) deep along the full length of the log.
There is a single board door in this wall, which extends only to the height of the top plates of the exterior walls. While the underside of the corrugated iron roof is exposed in the first room entered, in the second there is a tongue-and-groove timber board ceiling. A step in the slab also separates the two spaces.
Tongue-and-groove: One side and one end of the plank have a groove, the other side and end have a tongue (protruding wood along an edge's center). The tongue and groove fit snugly together, thus joining or aligning the planks, and are not visible once joined. Tongue-and-groove flooring can be installed by glue-down (both engineered and solid ...
39 in (990 mm) wainscoting using 3 in (76 mm) tongue and groove pine boards. Panelling (or paneling in the United States) is a millwork wall covering constructed from rigid or semi-rigid components. [1] These are traditionally interlocking wood, but could be plastic or other materials.
Ads
related to: tongue and groove boards exteriorebay.com has been visited by 1M+ users in the past month