enow.com Web Search

  1. Ads

    related to: tongue and groove boards exterior

Search results

  1. Results from the WOW.Com Content Network
  2. Matchboard - Wikipedia

    en.wikipedia.org/wiki/Matchboard

    Matchboard by definition is "a board with a groove cut along one edge and a tongue along the other so as to fit snugly with the edges of similarly cut boards." [1]Bramble Cottage on Lundy Island, weathered cedar matchboarding in an exposed location

  3. Tongue and groove - Wikipedia

    en.wikipedia.org/wiki/Tongue_and_groove

    Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles

  4. American historic carpentry - Wikipedia

    en.wikipedia.org/wiki/American_historic_carpentry

    Box houses (boxed house, box frame, [16] box and strip, [17] piano box, single-wall, board and batten, and many other names) have minimal framing in the corners and widely spaced in the exterior walls, but like the vertical plank wall houses, the vertical boards are structural. [18] The origins of boxed construction is unknown.

  5. Taabinga Homestead - Wikipedia

    en.wikipedia.org/wiki/Taabinga_Homestead

    There is a single board door in this wall, which extends only to the height of the top plates of the exterior walls. While the underside of the corrugated iron roof is exposed in the first room entered, in the second there is a tongue-and-groove timber board ceiling. A step in the slab also separates the two spaces.

  6. Joinery - Wikipedia

    en.wikipedia.org/wiki/Joinery

    Tongue and groove: Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint: Also called a bird's beak cut, this joint used in roof construction. A V-shaped cut in the rafter connects the rafter to the wall-plate. [11 ...

  7. Clapboard - Wikipedia

    en.wikipedia.org/wiki/Clapboard

    Later, the boards were radially sawn in a type of sawmill called a clapboard mill, producing vertical-grain clapboards. The more commonly used boards in New England are vertical-grain boards. Depending on the diameter of the log, cuts are made from 4 + 1 ⁄ 2 to 6 + 1 ⁄ 2 inches (110 to 170 mm) deep along the full length of the log.

  1. Ads

    related to: tongue and groove boards exterior