Search results
Results from the WOW.Com Content Network
The Mitsubishi Electric-owned Solae Test Tower in Inazawa City, Japan, is the world's second tallest elevator testing tower. [24] Mitsubishi Electric's United States headquarters in Cypress, California Mitsubishi Electric office in Canada. As of 2013, MELCO's business network around the world were the following: Mitsubishi Electric Global [25]
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
A cross-flow fan is a centrifugal fan in which the air flows straight through the fan instead of at a right angle. The rotor of a cross-flow fan is covered to create a pressure differential. A cross-flow fan has two walls outside the impeller and a thick vortex wall inside. The radial gap decreases in the direction of the impeller rotation.
An axial fan is a type of fan that causes gas to flow through it in an axial direction, parallel to the shaft about which the blades rotate. The flow is axial at entry and exit. The fan is designed to produce a pressure difference, and hence force, to cause a flow through the fan. Factors which determine the performance of the fan include the ...
A centrifugal fan is a mechanical device for moving air or other gases in a direction at an angle to the incoming fluid. Centrifugal fans often contain a ducted housing to direct outgoing air in a specific direction or across a heat sink; such a fan is also called a blower, blower fan, or squirrel-cage fan (because it looks like a hamster wheel).
Raj Matharu, 31, of Northridge, faces one count of possession with intent to distribute methamphetamine, according to the U.S. Attorney's Office.
Cycle lengths of signalized intersections are determined by small gears that are located within dial timers. Cycle gears, as they are commonly known, range from 35 seconds to 120 seconds. [citation needed] If a cycle gear in a dial timer results in a failure, it can be replaced with another cycle gear that would be appropriate to use. Since a ...
The latest version was used in the Mitsubishi Eclipse GT and Galant. Output in 2004 was 210 hp (157 kW; 213 PS) at 5500 rpm with 278 N⋅m (205 lbf⋅ft) of torque at 4000 rpm. In the older version, used in many Chrysler models since 1987, this V6 was an SOHC 12-valve developing 141 hp (105 kW; 143 PS) at 5000 rpm and 172 lb⋅ft (233 N⋅m) of ...