enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bondo (putty) - Wikipedia

   en.wikipedia.org/wiki/Bondo_(putty)

   Bondo is a polyester putty product originally marketed as an automotive body filler. Nowadays the brand name is used by 3M for a line of American-made products for automotive, marine and household repairs. [1] [2] The term Bondo is trademarked by 3M, but is commonly used to refer to any brand of automotive repair putty due to its popularity.

3. Fiberglass spray lay-up process - Wikipedia

   en.wikipedia.org/wiki/Fiberglass_spray_lay-up...

   The difference comes from the application of the fibre and resin material to the mould. Spray-up is an open-moulding composites fabrication process where resin and reinforcements are sprayed onto a reusable mould. The resin and glass may be applied separately or simultaneously "chopped" in a combined stream from a chopper gun.

4. J-B Weld - Wikipedia

   en.wikipedia.org/wiki/J-B_Weld

   The product consists of a resin and a hardener that need to be mixed before application. The mixture sets in 4-6 hours and fully cures in up to 15 hours. It can be used as an adhesive, laminate, plug, filler, sealant, or electrical insulator and can be drilled, ground, tapped, machined, sanded, and painted when cured.

5. Resin dispensing - Wikipedia

   en.wikipedia.org/wiki/Resin_dispensing

   A very good way is the use of piston metering heads. The ratio of resin to hardener can be determined exactly by the ratio of the width of two separate pistons, one for resin, one for hardener, where both pistons are pushed simultaneously. The amount is determined by a common stopper, limiting the stroke of both pistons equally.

6. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   The resin and hardener part together is known as the "Binder". As the name indicates, in Fusion bonded epoxy coatings the resin part is an "epoxy" type resin. “Epoxy” or “Oxirane” structure contains a three membered cyclic ring — one oxygen atom connected to two carbon atoms – in the resin molecule. This part is the most reactive ...

7. Fiberglass - Wikipedia

   en.wikipedia.org/wiki/Fiberglass

   The fiberglass spray lay-up process is similar to the hand lay-up process but differs in the application of the fiber and resin to the mold. Spray-up is an open-molding composites fabrication process where resin and reinforcements are sprayed onto a mold. The resin and glass may be applied separately or simultaneously "chopped" in a combined ...