enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Printed circuit board milling - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board_milling

   A milled printed circuit board. Printed circuit board milling (also: isolation milling) is the milling process used for removing areas of copper from a sheet of printed circuit board (PCB) material to recreate the pads, signal traces and structures according to patterns from a digital circuit board plan known as a layout file. [1]

3. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   Not to be confused with Printed electronics. For other uses, see PCB (disambiguation). "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the ...

4. Routing (electronic design automation) - Wikipedia

   en.wikipedia.org/wiki/Routing_(electronic_design...

   Modern PCB design software typically provides "interactive routers"—the drafter selects a pad and clicks a few places to give the EDA tool an idea of where to go, and the EDA tool tries to place wires as close to that path as possible without violating design rule checking (DRC). Some more advanced interactive routers have "push and shove ...

5. Perfboard - Wikipedia

   en.wikipedia.org/wiki/Perfboard

   Software for PCB layout can often be used to generate perfboard layouts as well. In this case, the designer positions the components so all leads fall on intersections of a 0.1 inches (2.54 mm) grid. In this case, the designer positions the components so all leads fall on intersections of a 0.1 inches (2.54 mm) grid.

6. Via (electronics) - Wikipedia

   en.wikipedia.org/wiki/Via_(electronics)

   In printed circuit board (PCB) design, a via consists of two pads in corresponding positions on different copper layers of the board, that are electrically connected by a hole through the board. [ citation needed ] The hole is made conductive by electroplating , or is lined with a tube or a rivet .

7. Stamped circuit board - Wikipedia

   en.wikipedia.org/wiki/Stamped_Circuit_Board

   the PCB (printed circuit board), plastic-injection molding and; the SCB. Using the SCB technology it is possible to structure and laminate the most widely differing material combinations in a reel-to-reel production process. [2] As the layers are structured separately, improved design concepts are able to be implemented.