enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   The terminal system consists of tabs (male) and receptacles (female). There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). A hand tool exists for inserting the terminals: the AMP Universal Handle. [citation needed]

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   An insulation-displacement contact (IDC), also known as insulation-piercing contact (IPC), is an electrical connector designed to be connected to the conductor(s) of an insulated cable by a connection process which forces a selectively sharpened blade or blades through the insulation, bypassing the need to strip the conductors of insulation ...

4. Electric wire ferrule - Wikipedia

   en.wikipedia.org/wiki/Electric_wire_ferrule

   Top: wire terminating in an insulated ferrule Center: Several ferrules with colored insulation, and two uninsulated ferrules Insulated, and uninsulated ferrules. An electric wire ferrule (sometimes electric end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal. Electrical insulation may be ...

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available.

6. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST connectors are electrical connectors manufactured to the design standards originally developed by J.S.T. Mfg. Co. (Japan Solderless Terminal). [1] JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors.

7. Point-to-point construction - Wikipedia

   en.wikipedia.org/wiki/Point-to-point_construction

   A terminal strip has stamped tin-plated copper terminals, each with a hole through which wire ends could be pushed, fitted on an insulating strip, usually made of a cheap, heat-resistant material such as synthetic-resin bonded paper , or bakelite reinforced with cotton. The insulator has an integral mounting bracket, sometimes electrically ...