Search results
Results from the WOW.Com Content Network
A bitwise OR is a binary operation that takes two bit patterns of equal length and performs the logical inclusive OR operation on each pair of corresponding bits. The result in each position is 0 if both bits are 0, while otherwise the result is 1.
If inline assembly language code is used, then an instruction that counts the number of 1's or 0's in the operand might be available; an operand with exactly one '1' bit is a power of 2. However, such an instruction may have greater latency than the bitwise method above.
The bitwise AND operator is a single ampersand: &. It is just a representation of AND which does its work on the bits of the operands rather than the truth value of the operands. Bitwise binary AND performs logical conjunction (shown in the table above) of the bits in each position of a number in its binary form.
Two to the power of n, written as 2 n, is the number of values in which the bits in a binary word of length n can be set, where each bit is either of two values. A word, interpreted as representing an integer in a range starting at zero, referred to as an "unsigned integer", can represent values from 0 (000...000 2) to 2 n − 1 (111...111 2) inclusively.
Another two sets were published by AMD: ABM (Advanced Bit Manipulation, which is also a subset of SSE4a implemented by Intel as part of SSE4.2 and BMI1), and TBM (Trailing Bit Manipulation, an extension introduced with Piledriver-based processors as an extension to BMI1, but dropped again in Zen-based processors). [1]
It is frequently stated that arithmetic right shifts are equivalent to division by a (positive, integral) power of the radix (e.g., a division by a power of 2 for binary numbers), and hence that division by a power of the radix can be optimized by implementing it as an arithmetic right shift. (A shifter is much simpler than a divider.
It is possible to use bitmasks to easily check the state of individual bits regardless of the other bits. To do this, turning off all the other bits using the bitwise AND is done as discussed above and the value is compared with 0. If it is equal to 0, then the bit was off, but if the value is any other value, then the bit was on.
The base-2 numeral system is a positional notation with a radix of 2.Each digit is referred to as bit, or binary digit.Because of its straightforward implementation in digital electronic circuitry using logic gates, the binary system is used by almost all modern computers and computer-based devices, as a preferred system of use, over various other human techniques of communication, because of ...