Search results
Results from the WOW.Com Content Network
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for duplex, bidirectional traffic. They usually use port numbers that match the services of the corresponding TCP or UDP implementation, if they exist.
A registered port is a network port designated for use with a certain protocol or application.. Registered port numbers are currently assigned by the Internet Assigned Numbers Authority (IANA) and were assigned by Internet Corporation for Assigned Names and Numbers (ICANN) before March 21, 2001, [1] and were assigned by the Information Sciences Institute (USC/ISI) before 1998.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
Such short-lived ports are allocated automatically within a predefined range of port numbers by the IP stack software of a computer operating system. The Transmission Control Protocol (TCP), the User Datagram Protocol (UDP), and the Stream Control Transmission Protocol (SCTP) typically use an ephemeral port for the client -end of a client ...
The most common transport protocols that use port numbers are the Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP); those port numbers are 16-bit unsigned numbers. A port number is always associated with a network address of a host, such as an IP address, and the type of transport protocol used for communication. It ...
The following ports are used for Microsoft Message Queuing operations: TCP: 1801; RPC: 135, 2101*, 2103*, 2105* UDP: 3527, 1801 * These port numbers may be incremented by 11 if the initial choice of RPC port is being used when Message Queuing initializes. Port 135 is queried to discover the 2xxx ports. [3]
In this case, protocol can be tcp, udp, tcpv6, or udpv6. If this parameter is used with -s to display statistics by protocol, protocol can be tcp, udp, icmp, ip, tcpv6, udpv6, icmpv6, or ipv6. Yes Yes Yes Yes Yes Yes -p: Show which processes are using which sockets (similar to -b under Windows) (you must be root to do this) No No Yes -P protocol
The typical home PC of the time had an external Hayes-compatible modem connected via an RS-232 port with an 8250 or 16550 UART which required this type of stack. Later, Microsoft would release their own TCP/IP add-on stack for Windows for Workgroups 3.11 and a native stack in Windows 95.