Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
There are four basic parameters that are involved in spin coating: solution viscosity, solid content (density), angular speed, and spin time. [13] A range of thicknesses can be achieved by spin coating. Most commonly the thicknesses range from 1-200 μm. The main properties that affect the thickness of the film are viscosity and spin speed.
Slot-die coating is a non-contact coating method, in which the slot-die is typically held over the substrate at a height several times higher than the target wet film thickness. [23] The coating fluid transfers from the slot-die to the substrate via a fluid bridge that spans the air gap between the slot-die lips and substrate surface.
From the high-spin (left) side of the d 7 Tanabe–Sugano diagram, the ground state is 4 T 1 (F), and the spin multiplicity is a quartet. The diagram shows that there are three quartet excited states: 4 T 2, 4 A 2, and 4 T 1 (P). From the diagram one can predict that there are three spin-allowed transitions.
The precursor sol can be either deposited on a substrate to form a film (e.g., by dip-coating or spin coating), cast into a suitable container with the desired shape (e.g., to obtain monolithic ceramics, glasses, fibers, membranes, aerogels), or used to synthesize powders (e.g., microspheres, nanospheres). [1]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Lasers are reflected off the wafer in a grid pattern and distortions in the grid are used to calculate the curvature as well as measure the optical constants. Strain in thin films can also be measured by x-ray diffraction or by milling a section of the film using a focused ion beam and monitoring the relaxation via scanning electron microscopy .
Spin glass when contrasted with a ferromagnet is defined as "disordered" magnetic state in which spins are aligned randomly or without a regular pattern and the couplings too are random. [1] A spin glass should not be confused with a "spin-on glass". The latter is a thin film, usually based on SiO 2, which is applied via spin coating.